MITSUBISHI ELECTRIC DX-VS1 - Manual (Page 37)

DX-VS1UE User DX-VS1UE User DX-VS1UE User DX-VS1UE User’’’’s Manual s Manual s Manual s Manual
36
is available.
Q. What kind of digital recorder can be connected with DX-VS1UE?
A. There is a function with which you can control a digital recorder on-line through DX-
VS1UE. DX-VS1UE is connected with a digital recorder via RS232-C. Mitsubishi DX-
TL800E can be used as a digital recorder which you can operate through DX-VS1UE.
Q. There seemes to be some problem when accessing DX-VS1UE. At one time I can access
the DX-VS1UE, but at other time, I cannot access the DX-VS1UE. How can I solve the
problem?
A. In many cases, this problem occurs in case you use cable line or xDSL line. You need to
use a router for get DX-VS1UE connecting to ISP. If the DX-VS1UE doesn’t use the line
for a while, Some ISPs compulsorily disconnect the session between DX-VS1UE and
them. It is because they would like to avoid the excessive load on their server and network
capacity which would occur without the forcible disconnection. If DX-VS1UE is discon-
nected by ISP, there is no way users can access DX-VS1UE. You can use session keep alive
function, which many kinds of routers equip, in order to get around such a situation. This
function makes it possible for DX-VS1UE to automatically connect to your ISP again when
disconnected.
Q. The ActiveX of DX-VS1UE cannot be downloaded automatically. What causes the
problem?
A. The ActiveX control of Internet Explorer is designed so that it can be downloaded to
user’s computer automatically and installed in it. However, if the registry information is
broken, it may be unable to be downloaded and installed to the computer. In order to solve
this problem, the installation program of DX-VS1UE ActiveX was prepared. Please use the
program.
1. Download the installation program.
2. Execute “DX-VS1Control installer.exe.”
Q. The setup program included in CD-ROM attached to DX-VS1UE cannot be executed.
What is the problem?
A. The setup program is a windows program based on MFC. If your OS doesn’t have
MFC42.dll inside or the MFC42.dll is not installed properly, the setup program doesn’t
work correctly. You have to install MFC42.DLL, if a message like “MFC42.DLL not
found” is displayed.
Installation procedure
1. Download MFC42.CAB.
2. Expand the .cab in a folder temporarily.
3. Execute “mfc42.exe”.
Q. Regarding the setup program, if one of DX-VS1UEs is chosen from the list box and the
“Change IP Addr” button is clicked, the setup program returns a message like “No re-
sponse”.
A. In case the option “Obtain an IP address automatically” is being used by IP setup of the
TCP/IP property(Start>Control Panel->Network(and Dial Up Config)), please change into
“Use the following IP address” temporarily. And change the configuration of subnet into