Micronics PENTIUM PRO W6-LI - Manual (Page 11)

W6-LI System Board Manual
Chapter 1: Quick Installation
9
STATIC!
Before
handling the
W6-LI, be
properly
grounded by
using a
special wrist
or ankle
strap, or
touch a
safely
grounded
object.
1
Chapter
Quick Installation
We know that many experienced people prefer to read as
little of the documentation as possible. If this sounds like
you, here’s the short form to get up and running quickly.
Installing the W6-LI
1. Make backup copies of your installation and configu-
ration diskettes.
2. Ground yourself to prevent damaging static dis-
charge, then remove the W6-LI from its packaging.
3. Configure and verify the system board’s jumper set-
tings (refer to Jumper Settings in Chapter 2).
4. Install the CPU and the system memory (refer to
Chapter 3).
5. Install the system board into the chassis and make all
necessary case connections.
6. Install any ISA and/or PCI add-on peripherals (refer to
Chapter 3).
7. Now you can connect any optional devices (refer to
Chapter 3).
8. Turn the computer on and press the <F2> key
when you see the screen in Figure 1.1.