Micronics PENTIUM PRO W6-LI User Manual

Page 36

Advertising
background image

W6-LI System Board Manual

Chapter 4: The BIOS Setup Utility

34

After the system is turned on and goes through a memory
test, the Power-Up screen (Figure 4-1) will appear on
your monitor:

Figure 4-1: Power-Up Screen

When “Press <F2> to enter SETUP” appears at the
bottom of the screen, press the <F2> key to begin the
Setup procedure. The CMOS Main Screen (Figure 4-2)
should appear and the prompt should be on the time
line. The Setup procedure can only be activated during
the boot sequence.

Advertising