Micronics PENTIUM PRO W6-LI - Manual (Page 44)

W6-LI System Board Manual
Chapter 4: The BIOS Setup Utility
Reset Configuration Data
Select Yes to reset Extended System Configuration Data
(ESCD) when you exit Setup. This selection allows the PnP
BIOS to detect your PCI and ISA PnP devices and reallo-
cate resources to them. The default setting is No.
PCI Configuration
Use this selection for additional setup menus to configure
PCI devices.
PS/2 Mouse
When disabled, this selection prevents the PS/2 mouse
from functioning and frees up IRQ12. Selecting Enabled
(default) allows the operating system to determine whether
to enable or disable the mouse.
Secured Setup Configuration
Select Yes if you want the system settings to be secured
from change by a Plug and Play operating system. The
default setting is No.
Large Disk Access Mode
If you are using a DOS operating system (MS-DOS, Novell
DOS or PC-DOS), set to DOS (default). If you are using
anything else, set to OTHER.
DRAM Type
The DRAM type can be set for Non-Parity (default),
Parity or ECC. Selecting ECC will detect the parity error
and allow the system to correct the error.
42