MITSUBISHI ELECTRIC SE2U - Manual (Page 18)

Installation 14
Installation
Choosing a Location
Your projector is designed to be installed in the four installation configurations shown here:
Floor front, Ceiling front, Floor rear, Ceiling rear. Your room layout or personal preference
will dictate which installation configuration you use.
For further information on the four configurations, please refer to page 28 .
If you place the projector above or below the screen, you have to tilt it down or up to center
the image on the screen, in these situations image distortion will occur. Use the Keystone
function to correct the distortion. See page 19 for keystone correction.
I. Floor front II. Ceiling front
III. Floor rear IV. Ceiling rear