MITSUBISHI ELECTRIC SE2U - Manual (Page 24)

Operation 20
Source Selection
To sequentially select input sources, press
SOURCE on the projector control panel or
the remote control. It may take you a few
seconds when the projector is searching for
input signals. The selected source will be
displayed at the bottom right of the screen
for 3 seconds. For a quick search, you can
also press the key repeatedly until your
desired signal is displayed.
Auto Adjustment
In some cases, you may need to optimize
the picture quality. To do this, press AUTO
POSITION on the control panel of the pro-
jector or AUTO on the remote control.
Within 3 seconds, the built-in Intelligent
Auto Adjustment function will re-adjust the
values of Frequency and Clock to provide
the best picture quality.
The current source information will be dis-
played at the bottom right of the screen for
3 seconds, as below.
Important:
• The screen will be blank while Auto is functioning.
• You can use Auto Adjustment function when only source is Analog RGB.