MITSUBISHI ELECTRIC SE2U User Manual
Page 8
4
Important Safeguards
Place of installation
For safety’s sake, do not use the projector at any place subjected to high temperature and
high humidity. Please maintain an operating temperature, humidity, and altitude as specified
below.
•
Operating temperature: between +41°F (+5°C) and +95°F (+35°C)
•
Operating humidity: between 30% and 90%
•
Never put any heat-producing device under the projector to prevent the projector from
being overheated.
•
Do not install the projector at a place that is unstable or subject to vibration.
•
Do not install the projector near any equipment that produces a strong magnetic field.
Also refrain from installing the projector near any cable carrying a large amount of
current.
•
Place the projector on a solid, vibration-free surface. Otherwise it may fall, causing
serious injury or damage.
•
Do not stand the projector on its end. It may fall, causing serious injury or damage.
•
Slanting the projector more than ±10˚(right and left) or ±15˚(front and rear) may cause
trouble or explosion of the lamp.
•
Do not place the projector near air-conditioning unit or heater to avoid the air outlet and
inlet grilles from being exposed to hot air.
•
Place the projector at least 50 cm (or 20 inch) away from the wall to prevent the air inlet
grille and the air outlet grilles that emit hot air from being blocked.