Choosing – Meridian America 541 User Manual
Page 43
Configuring the surround controller
37
To select a standard setting
Warning! Selecting Type will reset the 541 Surround Controller
to one of a standard set of configurations. If you want to make
changes to the configuration of an existing system use Config;
see Specifying information about your system on the next page.
With Config you can alter any Type to match any system.
●
Switch off any power amplifiers that are connected to the
surround controller.
●
Switch off the surround controller, using the power switch on
the back panel.
●
Switch on the power again while holding down the Off key on
the front panel.
The display will show:
Type
followed by:
Type 1
●
Press
A or V on the front panel to change the Type number.
For example, to select Type 3 for use
with a phono module the display shows:
Type 3 LP
●
Wait for one second, and then switch off the surround
controller using the power switch on the back panel.
●
Switch on again to use the standard settings you have
selected.