Meridian America 541 - Manual (Page 44)

Configuring the surround controller
38
If none of the standard settings exactly matches your
requirements choose the one that is closest, and then use the
541 Surround Controller’s configuration menus, called Config, to
make the necessary changes to the appropriate parameters.
The procedures for doing this are described in the following
sections of this chapter.
To specify the type of centre speaker
● Switch off the surround controller, using the power switch on
the back panel.
● Switch off any power amplifiers that are connected to the
surround controller.
● Switch on the power again while holding down the Display
key on the front panel.
The display will show:
Config
● Press > or < until you see a
display such as:
Centre Norm
Specifying information about your system
● Press A or V to step between the alternative options, as
shown in the following table:
Option Description
Norm Normal centre speaker; bass handled
by left and right main loudspeakers.
Wide Wide-range centre speaker, with good
bass response.
Phan No centre present; phantom centre
signal created by left and right main
loudspeakers.
When you have chosen the Centre option you want to use
proceed to the next step.