Monessen Hearth DSSNVMB - Manual (Page 15)

14 46D0550 46D0550 15
��
���
�
����
�
���
�
���
���
���
��
���
��
���
����
���
�
���
4. Remove adhesive backing from plastic clip. Press
clip to bottom of valve. Clip thermo bulb into plastic
clip. See Figure 10.
5. Reattach faceplate.
6. Install knob to shaft of t-stat sensor. See Figure 9,
page 14.
Figure 10 - Clipping Thermo Bulb into
Plastic Clip.
Valve
Thermo
Bulb
Plastic Clip
OPERATION OF THERMOSTAT SENSOR
1. Follow millivolt lighting instructions on lighting plate attached to unit or in homeowner’s manual.
2. With control knob in the “ON” position make sure the ON/OFF switch is in the “OFF” position. See Figure 11.
3. The unit is now being controlled by the thermostat sensor. The sensor will now cycle the burners on and off. You can
adjust how often the unit cycles by turning the control knob on the sensor.
Figure 11 - Control Knob in “ON” Position and ON/OFF Switch in “OFF” Position
Control
Knob
On/Off
Switch
ELECTRICAL WIRING (MILLI-VOLT)
T-Stat Sensor
Optional Blower