Marquis MW10 - Manual (Page 11)

1. HANDSET RETAINING HOOK
A removable clip to hold the handset secure when in the wall
mounted position is located below the hook switch.
Remove the clip hook, turn it 180 degrees round and slot it back
into place (figure 5).
1. UNSNAP
2. ROTATE 180 .
3. SNAP INTO PLACE.
2 4V 48V OFF
L1
L2
LABEL-FCC
LABEL-S/NO.
LABEL-IC
LABEL-ETL
WE D GE
2.S N A P IN TO PLAC E .
TAB S .
1.P R ES S TH E R E LE A S E
M OU N TING
11
2. INSTALLATION FOR WALL MOUNTING
Plug one end of the line cord into the line jack on the top of the
base unit.
Plug the other end of the line cord into the wall jack receptacle.
Guide the phone onto the studs on the wall jack.
Pull down firmly until you feel it snap into place.
The unit is now wall mounted (figure 6).
FIGURE 5
FIGURE 6
WALL MOUNTING