Marquis MW10 - Manual (Page 3)

FCC Part 15 Compliance
Warning Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and @an radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio TV technician for help.
Canadian Emissions Compliance
" This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian
Department of Communications. "
"Le present appareil numerique n'emet pas de bruits radiolectriques depassant les limites applicables auix appareils numeriques de la class B prescrites dans le Regle-
ment sur le brouillage radioelectrique edicte par le ministere des Communications du Canada."
Europe Compliance
The euromwb telephone has been approved to the following standards:
iCTR 37 AND TBR 38, EN 60950: 2000, EN 55022: 1998 CLASS B
EN 61000-4-2 1995 AS REQUIRED BY EN 55024: 1998
EN 61000-4-3 1996 AS REQUIRED BY EN 55024: 1998
EN 61000-4-4 1995 AS REQUIRED BY EN 55024: 1998
EN 61000-4-5 1995 AS REQUIRED BY EN 55024: 1998
EN 61000-4-6 1996 AS REQUIRED BY EN 55024: 1998
EN 61000-4-8 1995 AS REQUIRED BY EN 55024: 1998
3
SAFETY AND COMPLIANCE