Marquis MW10 - Manual (Page 17)

FLASH OPTIONS (STANDARD PROGRAMMING)
The EURO Series is pre-programmed with two standard flash options:
1. Option 1 is the programmable 100ms flash timing
2. Option 2 is the standard default of 600ms flash timing.
To change the flash to option 2, the 600ms flash timing:
1. Lift the handset.
2. Press the 'store' button to enter the programming mode.
3. Press digit 2 using the numeric dial pad.
4. Press digit 1 using the numeric dial pad.
5. Press the STORE button to store the new setting and to exit programming mode. A short beep should be heard to indicate a valid entry .
6. Hang up the handset.
Note: if a double beep is heard at any time during the programming, an invalid entry has been entered and the whole process must be
started all over again.
To change the flash back to option 1, the 100ms flash timing:
1. Lift the handset.
2. Press the 'store' button to enter the programming mode.
3. Press digit 2 using the numeric dial pad.
4. Press digit 0 using the numeric dial pad.
5. Press the 'store' button to store the new setting and to exit programming mode. A short beep should be heard to indicate a valid entry .
6. Hang up the handset.
Note: if a double beep is heard at any time during the programming, an invalid entry has been entered and the whole process must be
started all over again.
17
OPERATION