MITSUBISHI ELECTRIC T-60 - Manual (Page 13)

Installation
This chapter focuses on the steps necessary to unpack and install the T-60.
Read this section before attempting to apply the T-60. System installers
should read this chapter before attempting to install the unit into a cabinet,
or before connecting any electrical power to the T-60.
Unpacking and Inspection
Inspect the T-60’s shipping container. Is there evidence of damage or
mishandling? If damage exists contact your shipping carrier immediately.
EMERSON EMC cannot be held responsible for damage in shipment.
Compare the contents of the container with the packing list which is attached
to the exterior of the shipping container. Your T-60 shipping container
should include the following:
• T-60 with installed options
•
This manual
•
EMERSON BASIC PROGRAMMING GUIDE
• ApplicationBuilder diskettes
•
Mounting clips (four)
• Mounting brackets (two)
•
1/4" 8-32 Screws (four)
• Mounting template
• Optional cables and connectors as indicated on the packing list.
If any items are missing or
damaged, contact EMERSON
EMC immediately. •
A null modem cable
–
NMA 9 pin to 9 pin
–
NMX 25 pin to 25 pin
• TIA-XXX T-60 to DX Amplifier cable
Installation
Unpacking and Inspection
5