Multiquip Control Box Replacement LS60TD - Manual (Page 5)

LS60TD anD LS600 — COnTROL bOX RepLaCemenT — Rev. #1 (03/23/12) — page 5
COnTROL bOX pROgRamming
See„Figure„7„to„identify„control„box„switches.
Figure 7. Control Box Switches
Language Selection
1.„ Turn„the„IGNITION„switch„to„the„ON„position.„Do„not„
start„engine.
2.„ Place„the„FLOW„DIRECTION„switch„to„reverse.
3.„ Place„the„AUTOMATIC/JOG„switch„to„jog.
4.„ Place„the„CONTROL„switch„to„remote.
5.„ Manually„hold„the„CYLINDER„STROKE„switch„to„the„
jog„B„position.„While„holding„the„switch„to„the„jog„B„
position,„toggle„the„RESET„switch„down„5„times.„On„
the„fifth„time,„the„digital„screen„will„display„the„current„
set„language.„Toggle„RESET„switch„again„to„change„
language,„if„desired.
NOTICE
Control„boxes„come„pre-programmed„from„the„factory„
and„ configured„ to„ Model„ LS300.„ It„ is„ necessary„ to„
reprogram„the„model„configuration„to„match„your„unit.„
RESET
SCROLL
SET
VOLUME
FLOW
DIRECTION CONTROL
DECREASE INCREASE
FORWARD REVERSE LOCAL
IGNITION
REMOTE
OFF ON
START
CENTER
OFF
AUTOMATIC JOG JOG “A” JOG “B”
CYLINDER STROKE
MULTIQUIP INC. CARSON, CALIFORNIA 90746 USA
310-537-3700 800-421-1244 WWW.MULTIQUIP.COM
Digital Screen
Ignition Switch Reset Switch
Control Switch Automatic/Jog
Switch
Flow Direction
Switch
Cylinder Stroke
Switch
6.„ Once„„the„language„is„selected,„place„the„CONTROL„
switch„to„the„center„off„position.
7.„ Turn„the„IGNITION„switch„to„OFF„then„ON„again„to„
memorize„final„configuration.
machine model Configuration
1.„ Turn„the„IGNITION„switch„to„the„ON„position.„Do„not„
start„engine.
2.„ Place„the„FLOW„DIRECTION„switch„to„reverse.
3.„ Place„the„AUTOMATIC/JOG„switch„to„jog.
4.„ Place„the„CONTROL„switch„to„remote.
5.„ Manually„hold„the„CYLINDER„STROKE„switch„to„the„
jog„B„position.„While„holding„the„switch„to„the„jog„B„
position,„toggle„the„RESET„switch„down„5„times.„ after
the fifth time, move the CYLinDeR STROke switch
to the jog a position.„While„holding„the„switch„to„the„
jog„A„position,„toggle„the„RESET„switch„down„to„the„
desired„model„(LS60TD„or„LS600).
6.„ Once„ the„ model„ is„ selected,„ place„ the„ CONTROL„
switch„to„the„center„off„position.
7.„ Turn„the„IGNITION„switch„to„OFF„then„ON„again„to„
memorize„final„configuration.