Mitsubishi Motors 6A1 - Manual (Page 22)

6A1 ENGINE (E - W) - Timing Belt
11A-4-4
"
B
A
AUTO TENSIONER SETTING
(1) Set the auto tensioner in a vice, while making sure it
is not tilted.
(2) Slowly close the vice to force the rod in until the set
hole (A) of the rod is lined up with the set hole (B) of
the cylinder.
(3) Insert a 1.4 mm wire in the set hole.
(4) Remove the auto tensioner from the vice.
"
C
A
TIMING BELT INSTALLATION
(1) Turn the crankshaft sprocket so that its timing mark will
be away from the mating timing mark by approx. three
teeth.
Caution
D
If the timing marks are aligned, the piston is
brought to the TDC. When the camshaft is turned
under this condition, the valves may interfere with
the piston.
(2) Bring the timing marks of the camshaft sprockets as shown
in the illustration.
PWEE9622
E
Feb. 1997 Mitsubishi Motors Corporation
6AE0048
MB990767
MD998754
6AE0049
(A)
(B)
6AE0050
6AE0329
6AE0358
Timing mark