Maxi-Cosi Priori - Manual (Page 16)

With weakest hand
at belt path, tilt and
push the child
restraint forward
and back, and from
side to side. If the
seat belts do not
loosen, your child
restraint should be
secure.
NOTE: Some “play”
from front to back
or about an inch
from side to side is
acceptable. If it moves more, review
“Knowing your Vehicle Belts” and “The
Locking Clip” sections.
After checking for
hot seat and
buckles, secure
child as described
in “Securing Your
Child in the Child
Restraint” section.
5
WARNING !
Using this child restraint in any vehicle
seat where the lap belt cannot be
tightened securely and properly or
where it can be loosened by pulling on
it can result in serious injury or death.
4
Push down firmly
on the child restraint
and pull up on belt
to tighten. For a
manual belt, refer to
“Knowing your
Vehicle Belt”
section. Pull up on
shoulder strap to
remove any slack.
NOTE: Locking clip
is shown installed.
6
1
Rear-Facing Installation
with LATCH
To thread the
LATCH belt, put
belt end with
connector and
adjuster through
the rear-facing
belt path slot.
NOTE: Do not use the LATCH system
along with the adult lap or lap/shoulder
belt.
Rear Facing Use: 5-35 lbs. (2.3-16 kg), 19-36” (48-91 cm)
2
Thread UNDER
seat pad behind
the crotch strap
and out opposite
side.
Do not place
vehicle belt over
child’s legs.
3
Adjuster MUST be
on the left side of
child restraint as
shown. DO NOT
twist belt.
continued on next page. 28 29
4358-4274 US Priori 5/25/07 8:33 AM Page 31