Meyer Sound CueMixer Matrix3 - Manual (Page 17)

Enable Misc Console Modes
Enables these controls on the CueMixer. By default these are all of enabled until you use this command and select
"Disable" from the drop-down menus to disable the control on the CueMixer. The “Editing” controls are the ones
accessed by pressing Shift, and then using the Page 1, 2, 3, and 4 buttons.
Assign User A/B Cues
This external sets the Cue ID number to be fired when the User A or User B button is pressed. The default value
for all User buttons is cue 0 (zero). The hardware design of the CueMixer requires that all User buttons have an
assigned cue at all times. It is not possible to set the User buttons to Off. As a work-around to this limitation, the
CueMixer will not send Cue ID 0 (zero). In order to allow you to keep the User button from firing a cue, the default
setting is for the CueMixer not to send cue 0. If you need to assign Cue 0 to a User button, then you need to enable
the CueMixer to send cue 0. (please see Enable Cue 0 RIF).
17
CueMixer Setup