Meyer Sound CueMixer Matrix3 - Manual (Page 8)

RS-422
CueMixer LX-COS module
Port B
RS-422 Serial Cable
On the Matrix3 LX-COS module, Port A and Port B use the same connector pin-outs as the CueMixer, so the cable
connections are swapped from end to end. The cable needed to connect the LX-COS module to the CueMixer should
be wired as shown.
Use a two-shielded-pair stranded cable with low capacitance. Pins 4&5 are one pair, and 8&9 are the second pair.
(See the appendix for an application note on how to use two channels in an audio snake to run the CueMixer signal.)
8
Connecting the CueMixer