Meyer Sound CueMixer Matrix3 - Manual (Page 19)

Set Port on LX-300
Port B on the LX-COS module is the default port for connecting a CueMixer, but you can change the connection to
Port A. Please note that each LX-300 will only support one CueMixer.
User A Mode
This command is used to assign the Cues that are fired by last two rows of buttons on the CueMixer when you are
in User A mode.
Page
There are a total of 16 pages available.
Button
1 to 8 are the "Isolate" buttons left to right. 9 to 16 are the "Mute" buttons left to right.
Cue ID
This is the Cue ID number that is sent when the assigned button is pressed.
The User A Mode is entered by pressing and releasing the Shift button, and then immediately pressing the User A
button. The LED next to the User A button will light to show that you are in User A mode.
User A Mode: Select Page
When you are in the User A mode, the bottom two rows of buttons on the CueMixer are used to fire cues directly.
User A mode also uses the Page Select controls to give you 16 sets of 16 buttons. Selection is made by pressing
and releasing the Shift button, and then pressing one of the Isolate or Mute buttons. You can also change User A
Mode pages automatically with a subcue.
The same cue can be assigned to more than one button. When User A mode is on, the User A and User B buttons
are still active (as long as they have not been disabled).
User A Mode: Print Button Assignments
This command prints to the Log a list of the cues that have been assigned to User A Mode buttons.
19
User A Mode