Metz Plasma-TV-Set - Manual (Page 96)

96
Calling the menu
MENU
The settings of the satellite antenna system must
be entered in the menu "Configuration" so that
the TV set knows them.
These settings should always be made in the order
in which they are shown in the right-hand column
of the menu, starting at the bottom, i.e. LNB sup-
ply voltage, DiSEqC system, etc..
LNB supply voltage
The LNB voltages for selection of the polarisation
(horizontal H = 18V, vertical V = 14V) are alrea-
dy set and do not normally need to be changed.
If the cable to the satellite antenna is
very long, the voltages reaching the
LNB may be too low. In such cases, the
voltages can be increased by 1 V by
activating the line-compensation func-
tion.
If any changes should be necessary,
they can be made as follows.
Changing the settings
• Press the MENU key to open the TV
menu.
• Press the red key to open the
menu "Configuration".
• Press the appropriate numeric key (in this exam-
ple ᕥ to select "DVB-S".
• Press the OK key and, in the setting window,
use the - + key to switch the LNB supply voltage
on or off.
• Press the Ok key to confirm the new setting.
• Press the EXIT key to close the TV menu.
If the TV set is connected to a community
antenna, the LNB supply voltage must
always be set to "Off".
☞
A1. Set-up of satellite system
LNB supply voltage
i
General settings
Manuall search
Automatic search
Search settings
Satellite D
Satellite C
Satellite B
Astra 1
DiSEqC system
LNB supply voltage
Function for F2
Function for F1
EURO sockets
DVB-C
DVB-T
DVB-S
Analog-TV
Country
Language
Operating
LNB supply voltage on Power compensation off
Change with
Accept value with
F1 ➔
OK
– +
ᕥ
The number of subjects and sections depends
on the selected scope of operation. Depending
on the configuration of the TV set, the various
menu items may be displayed in a different
order and numbered differently.
OK
EXIT
605 47 2029.A2 LCD-GB 10.03.2006 8:53 Uhr Seite 96