Minolta DiMAGE Scan Multi PRO AF-5000 - Manual (Page 16)

16
USING THE SCSI INTERFACE
Setting the SCSI ID
1. Turn off the computer and all connected SCSI
devices.
2. Turn the SCSI terminator switch (Dip switch 4) to
ON.
3. Confirm which SCSI IDs are not being used.
4. Set the SCSI ID using the upper or lower SCSI ID
select buttons.
• Two operating SCSI devices in the same SCSI chain
cannot share a SCSI ID.
A SCSI ID is a unique address you assign to each SCSI device connected to your computer.
The SCSI ID range of your computer is from 0 to 7, however some ID's are already occupied.
IBM PC/AT
Macintosh
Occupied SCSI ID
7 - SCSI host adapter
0 - internal hard drive*
3 - internal CD ROM drive**
7 - operating system
* IDE Macintosh systems do not use SCSI ID 0 for the hard drive.
** SCSI ID 3 is available on the external bus on Macintosh systems with a dual bus.