Minolta DiMAGE Scan Multi PRO AF-5000 - Manual (Page 60)

60
FOCUS
The DiMAGE Scan Multi PRO uses the CCD sensor for autofocus.
Autofocus uses the centre of the image to determine focus. Normally, this results in an
excellent scan because the film plane is flat. However, if the film is warped or curled, or if
Autofocus is turned off in the preferences, focus may not be accurate. In this case, the focus
adjustment should be performed again using the point AF or Manual Focus function.
• Automatic autofocus can be turned on and off in the Preferences (see page 29).
POINT AF
This allows you to use autofocus on a specific area of the
image
1. Click on .
• The pointer will change to the Point AF icon.
• Click on [Point AF] button again to escape the function.
2. Click on the area of the image you wish to be in
sharp focus.
• Autofocus will begin, then a new prescan will start.
• The prescanned image will appear in the Prescan tab
when complete.