Minolta DiMAGE Scan Multi PRO AF-5000 - Manual (Page 17)

DiMAGE Scan Multi PRO
17
USING THE SCSI INTERFACE
4. Turn the SCSI terminator
switch (Dip switch 1) to
OFF.
• An external terminator is not
necessary with this scanner.
5. Plug the SCSI cable from
the next device into the
open port on the back of
the scanner.
IF THERE ARE OTHER DEVICES IN YOUR
SCSI CHAIN…
1. Place the scanner on a
level surface.
2. Connect one end of the
SCSI cable to either SCSI
port on the back of the
scanner
• Either SCSI port can be
used for other configurations,
there is no dedicated in or
out port.
3. Connect the other end of
the SCSI cable to the
SCSI port on the
computer or the last
device in the SCSI chain.
Connecting the SCSI Cable
This scanner has been packaged with the SCSI cable SC-P1. See your dealer if you require a
different SCSI cable.
• To meet FCC regulations, the SCSI cables used with this scanner must be equipped
with ferrite cores.
BEFORE YOU BEGIN…
TURN THE COMPUTER AND ALL
CONNECTED DEVICES OFF.