Mace DVR-9404 - Manual (Page 47)

Chapter 3 Main System Application
[Wave-in Device]:
Allow you to setup GV-System’s audio function. Each channel can be configured separately.
Choose the audio channel in the drop down list and adjust the parameters accordingly to your
specification. The Rec Audio option should be enabled if you wish to activate audio recording
function. The recording is control by the Monitor Sensitivity bar, which is adjustable from level
one to level 10; the higher the value the more sensitive it is to environmental sound and is
more likely to trigger the recording. The Gain Control bar allows you to add boost to the audio
input level.
Auto Reboot Setup
Click [Configure] button, select “Auto Reboot Setup” from the menu, and the following
dialog box will appear. Click on Auto Reboot System to enable this function and the settings
in the dialog box will be unlocked. In [Day Period] you may specify the day interval of each
auto-reboot (range from 1 ~14 days), and in [Reboot Time] specify in what time you want the
system to perform auto reboot.
The [WatchDog Reset if Reboot System Suspend and Fail] option is for avoiding system
lockup during an auto reboot. Enable this function allows the Watchdog function in your
GV-Series video capture card (available in GV-600, GV-650, GV-750, and GV-800 only) to
reset your system if auto reboot fail to restart for more than 5 minutes.
Note:
The WatchDog option will be closed if the option of “Auto run GV-System when window
startup” is not enable during the main application installation.
Page 42
DVR-9404~9408~9416 Mace Security Products
FOR ADDITIONAL QUESTIONS CONTACT TECHNICAL SUPPORT TEAM @ 1 (866) 392-MACE