Mace DVR-9404 - Manual (Page 8)

Chapter 1 Hardware Installation
Chapter 1
Hardware Installation
The Hardware components included in your system may vary depending on the model or optional features you
purchased. This chapter will describe all available hardware components of the GV-System and its
installation procedures.
1.1 Video Capture Device Installation
1.1.1 GV-100 Installation
The GV-100 support only one port and is the most basic model in the GV-Series. It does not
include any hardware components, but instead uses an USB webcam as its video capture
device. Technically speaking, just about any USB webcam supported by the Windows
operating system will work with the GV-100.
1. Plug in the USB camera into the USB port on your PC.
2. Windows will automatically detect the device. Now select the disk of USB camera to
install the drive.
1.1.2 GV-150 Installation
The GV-150 supports either 2 or 4 ports depending on the number of ports you purchased. It
uses an USB video grabber as the video capture device. One video grabber will support one
camera, therefore a 2 ports system will use two grabbers and a 4 ports system will use four
grabbers.
1. Plug in the USB adapter (Grabber) into the USB port on your PC.
2. Windows will automatically detect the device. Now select the driver path in the CD
directory \Driver\GV150 to install the driver.
linkav
LV - V100
GV-150 Video
Grabber
USB Interface
RCA Video In
S-Video In
Page 3
DVR-9404~9408~9416 Mace Security Products
FOR ADDITIONAL QUESTIONS CONTACT TECHNICAL SUPPORT TEAM @ 1 (866) 392-MACE