Monarch Instrument 9403TM - Manual (Page 22)

7. Place the roll of supplies on the supply platter so the black
marks pass the sensor.
8. Feed the supply through the supply sensor and slightly past
the printhead.
9. Slide the supply guide down the supply guide roller until it just
touches the edge of the supply strip.
10. Turn the printhead lever clockwise to close the printhead.
P r i n t i n g a Te s t L a b e l
Print a test label to see if your supply is loaded properly.
1. Turn the printer on. You will see
PRINT MODE
Ready
Supply
Guide
Printhead
Supply
Roll
Supply
Sensor
2-4 Loading Supplies