Monarch Instrument 9403TM - Manual (Page 34)

P r i n t P o s i t i o n
This function adjusts where data prints vertically on the supply.
Adjust the print if it is too close to the top or bottom of the supply,
or overtypes the pre-printed area (see the "MONARCH" sample).
One dot is 0.0049 inch.
◆ If the data is too close to the bottom, increase the number.
◆ If the data is too close to the top of the supply, decrease the
number.
Changing this setting only affects new
formats sent to the printer.
To change the setting, from the Main Menu select Setup, then
Supply. Then, follow these steps:
1. Press L or R until you see
SUPPLY
l Print Pos r
2. Press E. You will see the current setting, for example:
Enter print pos
[-99/99]: +0
4-4 Setting Supply Options