Motorola DS3478 - Manual (Page 285)

Advanced Data Formatting 15 - 31
Setup Field(s)
Move Cursor
Select one of the following Move Cursor options:
• Scan the Move Cursor To a Character bar code, then enter a character by scanning a bar code from the
Alphanumeric Keyboard on page 15-90 , to move the cursor to the position after the matching character. If the
character is not there, the rule fails and ADF tries the next rule.
• Scan the Move Cursor to Start bar code to move the cursor to the beginning of the data.
• Scan the Move Cursor Past Character bar code, then enter a character by scanning a bar code from the
Alphanumeric Keyboard on page 15-90 , to move the cursor past all sequential occurrences of this character.
For example, if the selected character is ‘A’, then the cursor moves past ‘A’, ‘AA’, ‘AAA’, etc. If the character is
not there, the cursor does not move (i.e., this has no effect).
Send Pause
Scan the bar code below to insert a pause in the transmission of data. To set the length of this pause, see Pause
Duration on page 15-8 .
Move Cursor To Character
Move Cursor To Start
Move Cursor Past Character
Send Pause