Multiquip DCA-600SSK - Manual (Page 47)

DCA-600SSK — OPERATION AND PARTS MANUAL (STD)— REV. #7 (04/30/10) — PAGE 47
DCA-600SSK— GENERATOR START-UP PROCEDURE (MANUAL)
14. The engine oil pressure gauge (Figure 54) will indicate
the oil pressure (kg/ cm 2 ) of the engine. Under normal
operating conditions the oil pressure is approximately
Figure 54. Oil Pressure Gauge
Figure 56. Engine Tachometer Gauge
16. The tachometer gauge (Figure 56) will indicate the
speed of the engine when the generator is operating.
Under normal operating conditions this speed is
approximately 1800 RPM’s.
15. The coolant temperature gauge (Figure 55) will indicate
the coolant temperature. Under normal operating
conditions the coolant temperature should be between
165 and 215 degrees Fahrenheit (
Green Zone).
Figure 55. Coolant Temperature Gauge
WATER TEMP
0
4
8
kg/cm2
ENGINE OIL PRESSURE
Figure 57. Main, Aux. and GFCI
Circuit Breakers (ON)
17. Place the main, GFCI, and aux. circuit breakers in the
“ON” position (Figure 57).
18. Observe the generator's ammeter (Figure 58) and verify
it reads the anticipated amount of current with respect
to the load. The ammeter will only display a current
reading if a load is in use.
19. The generator will run until manually stopped or an
abnormal condition occurs.
Figure 58. Ammeter (Load)