MicroNet Technology SP5101 - Manual (Page 77)

76
6.12 [sysconf] command
1. -print: display all current configurations.
2. -idtime: set the duration(in second) of two pressed digits in dial mode
as timed out. If after the duration user hasn’t pressed next
number, SIP Phone will dial out all number pressed.
3. -keypad: set DTMF type .User can select DTMF type SIP Phone
receive and transmit.(sysconf –keypad 0/1 , 0 for in band ,1
for RFC2833.)
4. -2833type: change RFC2833 Payload type.
5. -eod: select end of dialing key, e.g. set end of dial key as “＊” button ,
after finished pressing dialing number then press “＊” will dial
out. (sysconf –eod 0/1/2 , 0 for no end of dial key , 1 for “＊”
button, 2 for “#” button )
6. –privacy: this function can only work in Japan and also user’s service
platform supports Japan
standard telecom CLIR specification. When this function is set
as Japan mode, other users can hide their caller ID by press
special code before dial out phone number.
7. –phone: set in SIP message to add user=phone parameter or not. If
user enables this function, in SIP message will add this
parameter.
8. –waiting: User can enable or disable Call Waiting function.
9. –transfer: User can enable or disable Transfer function.
10 –pick: Set Call Group Pick up Code. After setting this code, user can
do Group Call Pick Up with this special code.
11. –spick: Set Call Specific Pick up Code. After setting this code, user
can do Single Call Pick Up with this special code
12. –park: Set Call Park Code. Set special access code for Call Park
function.
13. –mwi: Enable/Disable MWI function and specify MWI method to be
client or server-based. (0: OFF, 1: Client(Subscribe),2:
Proxy(NOTIFY))
14. –mwiexpires: If user set MWI method as client-based. Here can
define the interval time of phone to send subscribe
message to check voice mail.
15. –mwinumber: Set voice mail box number.
16. –atanswer: enable/disable auto answer function of Phone. If this
function is enabled, phone will answer incoming
automatically.