MaxTech PCI Internal Voice/FAX/Data/Speakerphone Modem - Manual (Page 14)

12
Default is 5
\N_ \N0 Normal data-link only
\N1 Normal data-link only
\N2 MNP data link only
\N3 V.42/MNP/Normal data link
\N4 V.42 data link only
\O Initiate reliable link during a normal link
\Q_ \Q0 Turn off flow control
\Q1 XON/XOFF software flow control
\Q2 CTS signal unidirectional hardware flow
control
\Q3 RTS/CTS signal bi-directional
hardware flow control
\T n Inactivity timer, where n = 0 to 90 minutes.
Default is 0
\U Accept reliable link during a normal link
\X_ \X0 Process XON/XOFF but don’t pass
through
\X1 Process XON/XOFF and pass through
\Y Switch to reliable link from normal link
\Z End the reliable connection and switch to
normal operation
-J -J0 Disable error control detection phase
-J1 Enable error control detection
phase
"H "H0 V.42bis data compression disabled
"H1 Can send but not receive V.42bis data
compression
"H2 Can receive but not send V.42bis data
compression
"H3 Bidirectional V.42bis data
compression enabled
"O n Set maximum V.42bis data block size to
n
(n=6-250). Default is 32
3.6 Fax Class 1 Commands
+FAE=n Data/Fax auto answer enable. Default is
0
+FCLASS=1 Sets FAX operating mode
+FRH=n Receive HDLC data
+FRM=n Receive data
+FRS=n Wait for silence