MaxTech PCI Internal Voice/FAX/Data/Speakerphone Modem - Manual (Page 19)

17
Modem experiences bursts of errors or
suddenly disconnects while communicating
with a remote modem.
1. Make sure Call Waiting is turned off.
2. Make sure the phone line does not exhibit excess
noise.
Section Seven - Support and Service
In the unlikely event you experience difficulty in the
use of this product, we suggest you: (1) consult the
Troubleshooting section of this guide and (2) consult with
your dealer. To obtain service for this product, follow the
Return Merchandise Authorization Procedure as outlined
in the Warranty card.
Appendix A - Specifications
Communication Std. V.90, x2, V.34+ , V.34, V.32bis, V.32, V.29,
V.27ter, V.22bis, V.23, V.22, V.21, V.17,
Bell212/103
Data Compression: V.42bis/MNP5
Error Correction: V.42/MNP2-4
Host Interface: PCI
FAX Group: Group III Send/Receive Standard
FAX Command set: EIA/TIA-578 Service Class 1
Speakerphone:
Full-Duplex
Transmit level: -10dBm
Receiver sensitivity: -36dBm
UART:
16550 compatible
Data format: 300-115200 bps (8N1, 7E1, 7E2, 7O1, 7O2)
Power: 0.75 W
Temperature: 0-55 degrees C (operating); -20 to 80 de-
grees C (non-operating)
Appendix B - Notices
FCC Compliance
This equipment complies with Part 68 of the FCC Rules. On this
equipment is a label that contains, among other information, the
FCC registration number and Ringer Equivalence Number (REN)
for this equipment. You must, upon request, provide this informa-
tion to your telephone company.
If your telephone equipment causes harm to the telephone
network, the Telephone Company may discontinue your service
temporarily. If possible, they will notify in advance. But, if
advance notice isn’t practical, you will be notified as soon as
possible. You will be informed of your right to file a complaint with