MaxTech PCI Internal Voice/FAX/Data/Speakerphone Modem - Manual (Page 5)

3
2.4 Hardware Configuration
The version of Windows 9x you have will determine
which set of dialog boxes is presented to you when
installing the modem in Windows 9x. Proceed to one of the
following sections, depending on your Windows 9x's
diaglog box:
• Section 2.4.1 when Windows 95 starts for
the first time after card installation, it detects
the modem and it displays the New Hard-
ware Found dialog box
• Section 2.4.1.1 when Windows 95 starts for
the first time after card installation, it detects
the modem and it displays the Update Device
Driver Wizard.
• Section 2.4.1.2 When Windows 98 starts for
the first time after card installation, it detects
the adapter and displays the Add New
Hardware Wizard.
2.4.1 Windows 95 Release 4.00.950
When Windows 95 starts for the first time after card
installation, it detects the modem and displays the New
Hardware Found dialog box.
Under New Hardware Found, when asked to
“Select which driver you want to install for your new
hardware,” click on “Driver from disk provided by hard-
ware manufacturer.” Click “OK.”
The Install From Disk dialog box now instructs
you to “Insert the manufacturer's installation disk into the
drive selected, and then click OK.” Insert the modem's
driver diskette into the disk drive and type A:\ (or B:\ if
inserted in drive B) in the “Copy manufacturer's files
from:” box. Click “OK.”
Windows 95 may request its own installation disks
or CD-ROM for some files. Insert the Windows 95 disks
or CD-ROM as required. When all necessary files are
copied, the modem is configured. Windows 95 will assign
the modem a COM port and IRQ line. Proceed to Section
2.5.