MaxTech PCI Internal Voice/FAX/Data/Speakerphone Modem - Manual (Page 4)

2
2.3 Hardware Installation
Installation of this modem requires opening and
manipulating your PC. Exercise caution at all times when
working with AC powered and static-sensitive equip-
ment. Turn off and unplug your PC before installation.
Discharge any static electricity from your body by touch-
ing any grounded metal surface of the PC system, such
as its power supply cover.
1. Turn off and unplug your computer from the AC
outlet.
2. Remove your computer's cover (refer to your
computer's owner's manual).
3. Select any available 32-bit PCI card slot and remove
the slot cover (refer to Figure 2-3).
Figure 2-3 PCI Expansion Slots
4. Carefully slide the PCI internal modem into the slot
you have chosen, applying even pressure until the
modem is completely seated in the slot.
5. Fasten the retaining bracket with the screw from
the slot cover. Make sure the modem is properly
aligned. Store the slot cover for future use.
6. Replace the computer cover and plug in your com-
puter.
7. Connect the telephone cable from the modem's LINE
connector to the telephone wall jack.
8. Optionally, connect your telephone to the modem's
PHONE connector, a microphone to the MIC con-
nector and a speaker to the SPK connector.
9. Turn your computer on. Your modem is now in-
stalled.