Result codes, Connect messages, Messages – Multi-Tech Systems MT5634ZBA User Manual
Page 39
Chapter 4 - AT Commands, S-Registers, Result Codes
39
MultiModemDID User Guide
Result Codes
In command mode your modem can send responses called
result codes to your
computer. Result codes are used by communications programs and can also appear
on your monitor.
Terse
Verbose
Description
0
OK
Command executed
1
CONNECT
Modem connected to line
2
RING
Ring signal detected
3
NO CARRIER
Carrier signal lost or not detected
4
ERROR
Invalid command
5
CONNECT 1200 *
Connected at 1200 bps
6
NO DIALTONE
No dial tone detected
7
BUSY
Busy signal detected
8
NO ANSWER
No answer at remote end
10
CONNECT 2400 *
Connected at 2400 bps
11
CONNECT 4800 *
Connected at 4800 bps
12
CONNECT 9600 *
Connected at 9600 bps
13
CONNECT 14400 *
Connected at 14400 bps
14
CONNECT 19200 *
Connected at 19200 bps
24
CONNECT 7200 *
Connected at 7200 bps
25
CONNECT 12000 *
Connected at 12000 bps
26
CONNECT 16800 *
Connected at 16800 bps
40
CONNECT 300 *
Connected at 300 bps
55
CONNECT 21600 *
Connected at 21600 bps
56
CONNECT 24000 *
Connected at 24000 bps
57
CONNECT 26400 *
Connected at 26400 bps
58
CONNECT 28800 *
Connected at 28800 bps
59
CONNECT 31200 *
Connected at 31200 bps
60
CONNECT 33600 *
Connected at 33600 bps
70
CONNECT 32000 *
Connected at 32000 bps, 56K rate
71
CONNECT 34000 *
Connected at 34000 bps, 56K rate
72
CONNECT 36000 *
Connected at 36000 bps, 56K rate
73
CONNECT 38000 *
Connected at 38000 bps, 56K rate
74
CONNECT 40000 *
Connected at 40000 bps, 56K rate
75
CONNECT 42000 *
Connected at 42000 bps, 56K rate
76
CONNECT 44000 *
Connected at 44000 bps, 56K rate
77
CONNECT 46000 *
Connected at 46000 bps, 56K rate
78
CONNECT 48000 *
Connected at 48000 bps, 56K rate
79
CONNECT 50000 *
Connected at 50000 bps, 56K rate
80
CONNECT 52000 *
Connected at 52000 bps, 56K rate
81
CONNECT 54000 *
Connected at 54000 bps, 56K rate
82
CONNECT 56000 *
Connected at 56000 bps, 56K rate
88
DELAYED
Delay is in effect for the dialed number
89
BLACKLISTED
Dialed number is blacklisted
90
BLACKLIST FULL
Blacklist is full
*
When the extended result code configuration option is enabled, one of the following codes is
appended to the result code, depending on the type of error control connection:
V42bis – V.42 error control (LAP-M) and V.42bis data compression
V42 – V.42 error control (LAP-M) only
MNP5 – MNP 4 error control and MNP 5 data compression
MNP4 – MNP 4 error control only
NoEC – No error control protocol