Motorola TMS320C6711D - Manual (Page 3)

TMS320C6711D
FLOATINGĆPOINT DIGITAL SIGNAL PROCESSOR
SPRS292A − OCTOBER 2005 − REVISED NOVEMBER 2005
3 POST OFFICE BOX 1443
•
HOUSTON, TEXAS 77251−1443
REVISION HISTORY
The TMS320C6711D device-specific documentation has been split from TMS320C6711, TMS320C6711B,
TMS320C6711C, TMS320C6711D Floating−Point Digital Signal Processors, literature number SPRS088N, into a
separate Data Sheet, literature number SPRS292. It also highlights technical changes made to SPRS292 to gen-
erate SPRS292A; these changes are marked by “[Revision A]” in the Revision History table below.
Scope: Updated information on McBSP and JTAG for clarification. Changed Pin Description for A12 and B11
(Revisions SPRS292 and SPRS292A). Updated Nomenclature figure by adding device−specific information for
the ZDP package. Updated Characteristics of the Processor table with device−specific information (footnote) for
the ZDP package
TI Recommends for new designs that the following pins be configured as such:
D
Pin A12 connected directly to CV
DD
(core power)
D
Pin B11 connected directly to V
ss
(ground)
PAGE(S)
NO.
ADDITIONS/CHANGES/DELETIONS
21 Device Configurations, Device Configurations Pins at Device Reset (HD[4:3], HD8, HD12, and CLKMODE0) section:
Removed “CE1 width 32−bit” from Functional Description for “00” in HD[4:3](BOOTMODE) Configuration Pin
25 Terminal Functions, Resets and Interrupts section:
Updated IPU/IPD for RESET Signal Name from “IPU” to “−−”
26 Terminal Functions, Host Port Interface section:
Removed “CE1 width 32−bit” from Description for “00” in Bootmode HD[4:3]
31 Terminal Functions, Reserved for Test section:
Updated Description for RSV Signal Name, A12 GDP/ZDP
Updated Description for RSV Signal Name, B11 GDP/ZDP
31 Terminal Functions, Reserved for Test section:
Updated/changed Description for RSV Signal Name, A12 GDP (to “recommended”) − [Revision A]
Updated/changed Description for RSV Signal Name, B11 GDP (to “recommended”) − [Revision A]
38 Device Support, device and development-support tool nomenclature:
Updated figure for clarity
39 Device Support, documentation support section:
Updated paragraphs for clarity
58 IEEE 1149.1 JTAG Compatibility Statement section:
Updated/added paragraphs for clarity
62 Recommended Operating Conditions:
Added VOS, Maximum voltage during overshoot row and associated footnote
Added VUS, Maximum voltage during undershoot row and associated footnote
65 Parameter Measurement Information:
AC transient rise/fall time specifications section:
Added AC Transient Specification Rise Time figure
Added AC Transient Specification Fall Time figure
93 MULTICHANNEL BUFFERED SERIAL PORT TIMING:
switching characteristics over recommended operating conditions for McBSP section:
Updated McBSP Timings figure for clarification