Motorola EX500 - Manual (Page 25)

23
English
SC
AN
SCAN
You can monitor several channels in order to
receive any call that is transmitted on any of
these channels. Sixteen different channels can
be programmed into a scan list. Each channel
can share the same scan list or have different
scan lists assigned to them.
Once the radio’s scan operation is activated
and the radio detects a call coming through a
channel in its scan list, it switches to that
channel for you to receive the call.
STARTING OR STOPPING A SCAN
OPERATION
The LED Indicator will blink (green) during a
scan operation. It will stop blinking when the
radio switches to a channel.
TALKBACK
If the programmable Talkback option is set, you
can respond to any calls received during the
scan operation by pressing the PTT button
before the programmed hang-time ends.
Check with your dealer for details.
DELETING A NUISANCE CHANNEL
If a channel continually generates unwanted
calls/noise, you can temporarily remove it from
the scan list by performing a Nuisance
Channel Delete operation.
Note: You cannot perform a Nuisance Chan-
nel Delete on a priority channel or if
there is only one remaining channel in
the scan list.
1 Press the Scan button ( see page 17 ) to start
a scan operation.
2 Press the Scan button again to stop the scan
operation.
1 While the radio is on the Nuisance Channel,
press and hold the Scan button (
see page
17 ) until you hear a tone.
2 Release the Scan button.
05_Scan.fm Page 23 Friday, July 22, 2005 11:13 AM