Motorola EX500 User Manual
Page 36
Receiving a Call
1.
Turn radio on.
2.
Adjust volume level.
3.
Switch to desired channel.
4.
If at any time a call comes through, it will be heard at the
volume level set.
Emergency Alarm
1.
Press programmed Emergency button to initiate Emer-
gency Alarm/Siren.
2.
Press and hold Emergency button to cancel Emergency
Alarm/Siren.
3.
Press and release Emergency button to restart Emergency
sequence.
Starting or Stopping a Scan Operation
The LED Indicator will blink (green) during a scan operation. It
will stop blinking when the radio switches to a channel.
1.
Press the preprogrammed Scan button to start a scan oper-
ation.
2.
Press the preprogrammed Scan button again to stop the
scan operation.
Deleting a Nuisance Channel
1.
While radio is on a Nuisance Channel, press and hold the
preprogrammed Scan button until a tone is sounded.
2.
Release the preprogrammed Scan button.
Turning On the Radio
•
Turn On/Off/Volume knob clockwise. Self Test Pass Tone
will sound and green LED will light up if radio powers up
successfully. If radio fails power up, the Self Test Fail Tone
will sound.
Turning Off the Radio
•
Turn On/Off/Volume knob counter-clockwise, until click is
heard.
Adjusting the Radio’s Volume
1.
Press and hold Volume Set button until continuous tone is
sounded.
2.
Turn On/Off/Volume knob to adjust volume level.
3.
Release Volume Set button when desired level is achieved.
Selecting a Radio Channel
•
Turn Channel Selector knob clockwise or counter-clock-
wise to reach desired channel.
Sending a Call
1.
Turn on radio.
2.
Use Channel Selector knob to select the desired channel.
3.
Press PTT button, and speak clearly with mouth about 2.5
to 5 cm (one to two inches) away from microphone.
4.
Release PTT button when call is completed.
08_QuickRef.fm Page 34 Friday, July 22, 2005 11:28 AM