MITSUBISHI ELECTRIC MIM-G01 - Manual (Page 36)

+CNUM – Own Number
This Command sets the own number (MSISDN) of the SIM card for any service.
Defined parameters:
<alphax>
name for the number <numberx>
<numberx> number in format determined by <typex>
<typex> type of adresse-byte in integer format
Example:
+CNUM :"Phone", "0612345678",129
+CNUM :"Fax", "0687654321",129
+CSCA – SMS Center Number
This Command requests or changes the SMSC number saved on the SIM card.
Defined parameters:
<number>
SMSC number
+IPR – Baudrate
This Command sets baudrate of serial interface.
Defined parameters:
<rate>
Data rate in bps (0 = Autobauding)
AT Commands MIM-G01 Appendix
8 - 2 MITSUBISHI ELECTRIC
Command Possible answers
AT+CNUM
Note: request MSISDNs
+CNUM : <alpha1>, <number1>, <type1> <CR><LF>
+CNUM : <alpha2>, <number2>, <type2>....
Tab. 8-3: +CNUM – Own Number
Command Possible answers
AT+CSCA?
Note: request SMSC number
+CMS ERROR: 330
Note: service center unknown
+CMS <number>
Note: number of SMSC
AT+CSCA="<number>"
Note: save Service Center number
OK
Tab. 8-4: +CSCA – SMS Center Number
Command Possible answers
AT+IPR? +IPR: <rate>
OK
AT+IPR=<rate>
Note: disable autobauding and set given
baudrate.
OK
Tab. 8-5: +IPR – Baudrate