MITSUBISHI ELECTRIC MIM-G01 - Manual (Page 47)

8.2.4 Message Commands
In Message Mode, you can send this extended command set to the modem.
If you use this command in Modem Mode, an error will occur.
Overview of the Commands
Overview of the Commands
AT+T Send="All; ..."
sets general send parameters
AT+T Send="SMS; ..." sends an SMS message (depending on device)
AT+T Send="Fax; ..." sends a fax (depending on device)
AT+T Send="EMail; ..." sends an Internet e-mail
AT+T Send="POP3; ..." retrieves Internet e-mail from provider
AT+T Send="Express; ..." sends an Express E-Mail
Control and Configuration
AT+T Send?
displays the current configuration
AT+T List displays a list of the messages received
AT+T Read displays received messages
AT+T Delete deletes received messages
AT+T Time sets the system time
AT+T Time? displays the system time
AT+T Echo switches the local echo on or off
AT+T Verbose switches comprehensive feedback on or off
AT+T Speaker sets the sound level of the modem speaker
AT+T Answer switches the call receipt on or off
AT+T Erase resets the modem (factory default)
AT+T Redial sets the number of redial attempts (default=0)
AT+T RedialDelay defines the delay time between redial attempts (default=90)
AT+T DialRules defines dial method and dial tone detection
AT+T Mode switches between modem mode and Message Mode
AT+T Help displays an overview of the extended commands
AT+T Format defines data format on serial interface
Remote Dial-In
AT+T Send="TransMode; ."
Remote dial-in to a Tixi modem and transparent mode via the
RS 232 connection to the connected control unit
Appendix AT Commands MIM-A01
Mitsubishi Industrial Modem 8 - 13