Removing and replacing the keypad – Motorola CDMA 800/1900 MHz User Manual
Page 38
38
May 15, 2006
6809495A97-O
Disassembly
Q CDMA
Removing and Replacing the Keypad
1.
Remove the antenna, battery cover, battery, rear housing assembly, flex
connector, transceiver board assembly, and keyboard as described in the
procedures.
2.
Use the metal tweezers to lift the keypad from the front housing as shown in
Figure 26.
3.
To replace, insert the keypad into the front housing. Align the slots at the sides
of the keypad metal supports to the keypad latches in the front housing.
4.
Top tab of keypad should fit underneath the main lens.
5.
Ensure the alignment holes align properly with the alignment pins in the front
housing.
6.
Replace the keyboard, main board, camera assembly, daughter board, antenna,
rear housing assembly, battery, and battery door as described in the
procedures.
060318o
Figure 26. Removing the Keypad
Keypad latches
Keypad
Alignment
Hole