Motorola E398 GSM - Manual (Page 29)

6809480A37-O April 21, 2004 29
Level 1 and 2 Service Manual Disassembly
Removing and Replacing the MFT Chamber Assembly and Camera
1. Remove the battery cover, battery, rear housing, and transceiver PC board as
described in the procedures.
2. Disengage the two plastic MFT Chamber assembly side connectors from the
transceiver PC board and lift up the MFT Chamber assembly as shown in
Figure 15.
3. Using the disassembly tool, gently pry up the camera flex connector from the
transceiver PC board.
4. To replace, place the camera flex connector on the transceiver PC board camera
connector and press it into place.
5. Fold over the MFT Chamber assembly, aligning the camera with the camera
hole in the MFT Chamber and press into place engaging the two plastic side
clips on to the transceiver PC board.
6. Replace the transceiver PC board, rear housing, battery, and battery cover as
described in the procedures.
Figure 15. Removing and Replacing the MFT Chamber Assembly
Disassembly Tool Side Clips
Disassembly Tool MFT Chamber Assembly
Disassembly Tool Disassembly Tool
Disassembly Tool Camera Flex Connector
assembly To Camera