Mark Levinson N390S - Manual (Page 30)

30
Remote Control, Nº390S
1. IR Transmitter window
The Nº390S’s Remote Control sends infrared (IR) commands
through its projection lens, and the Nº390S receives IR
commands through its Remote sensor window. (See “Front
Panel, Nº390S”). If either of these lenses is obstructed, no IR
commands can be received by the Nº390S. If you notice IR
performance deteriorating, you may want to clean these lenses
with a soft cloth and some glass cleaner. (Spray the cleaner on
the cloth first, and then wipe the lens with the moistened
cloth. Do not spray the cleaner directly on either lens, as this
may allow moisture to migrate into the electronics behind the
lens assemblies.)
2. Transport Buttons
The buttons used for routine operation of transport functions
on the Nº390S are grouped at the top of the remote control.
They include:
• rew ( )
When clicked, this will take you to the beginning of the
previous
track. ( is the international symbol for previous).
When pressed and held (denoted by the bold dot •), the
Nº390S will enter a reverse scanning mode similar to the
familiar rewind function of many tape decks, allowing a
precise location within a track to be found. This scan may
be silent or audible, depending on your setup: sound
preferences. (See Special Functions.)
• f.fwd ( )
When clicked, this will take you to the beginning of the
next
track. ( is the international symbol for next). When
pressed and held (denoted by the bold dot •), the Nº390S
will enter a fast forward scanning mode similar to the
familiar fast forward function of many tape decks, allowing
a precise location within a track to be found. This scan
may be silent or audible, depending on your setup: sound
preferences. (See Special Functions.)
• play ( )
Press to enter the play mode from either stop or standby,
or to restart play at the beginning of the track currently
playing. If there is no disc inside the Nº390S, pressing play
will open the drawer so you may add a disc.