Mark Levinson N390S - Manual (Page 31)

31
• stop/dwr ( )
Press to stop play. The same button will operate the drawer
if stopping the disc has no relevance (e.g., if it is already
stopped, or if there is no disc inside the Nº390S).
• pause ( )
Press to pause play in the current location. If left in pause
mode for more than two minutes, the Nº390S will enter
extended pause
mode, shutting down both the laser and
the drive motors to enhance longevity and reliability.
Upon pressing pause a second time, the disc will spin up
and begin playing from the location where it had been
paused.
3. A/B repeat button
The Nº390S may be set to repeat any contiguous segment of a
disc. Press once to establish a beginning point (point A) for an
endless playback loop. The display will flash the letter B to
indicate that it is ready to accept your designated ending
point (point B). (Note that A must precede B on the disc.)
Once this has been done, the Nº390S will repeat the segment
of the disc between points A and B until you press stop or A-B
again.
4. mode buttons
Using these three buttons, either of two Nº390S functions can
be controlled from the remote control:
• PROGRAM (for creating custom play lists)
• TIMES (for selecting a time indication)
Either of these modes may be accessed by repeatedly pressing
the mode button, thereby toggling back and forth between
the options.
Once a particular mode is chosen, pressing the mode + and
mode –
buttons “increases” or “decreases” that particular
function. For example, mode + would either: add a track to a
play list; or advance to the next time indication.
Along with mode + and mode –, the mode button is also used
to change the option settings. (See Special Functions.)
For detailed information on programming the Nº390S, see
Programming the Nº390S later in this manual.