Mark Levinson N390S - Manual (Page 36)

36
Setup and Installation
Caution! For your protection, review “Important Safety Instructions”
before you install your Nº390S.
Connecting AC Mains Plug the female end of the AC power cord into the appropriate
socket on the rear panel of the Nº390S, being certain to seat it
firmly, all the way into the receptacle.
Double-check to make sure that the AC power switch is in the off
position (the side of the switch with an “O” should be depressed),
and also that the voltage indicated on your Nº390S corresponds to
the normal voltage for your country. (Connecting a 120-volt
Nº390S to a 220-volt AC outlet is not a good idea.)
Plug the male end of the power cord into the wall outlet, and
then turn on the power switch located on the rear panel of the
Nº390S (by depressing the side of the switch that has a single
vertical line like this: “|”).
Connecting Digital The Nº390S incorporates EIAJ optical and RCA digital input
Audio Sources connectors for up to two additional digital sources. (See Rear
panel, Nº390S.)
For optical digital interconnection, we recommend the use of
better quality optical EIAJ cable. Your dealer can help you select
an appropriate cable for your system.
Using appropriate cables, connect an output of each additional
source (laser disc, digital tape, etc.) to the appropriate input on
your Nº390S.