Mark Levinson N390S - Manual (Page 44)

44
Note: If you try to review a nonexistent play list, the display will
show NO PGM.
4. To view the next selection, press mode + again, and so on.
5. After you view the last selection, one more press of mode +
will cause the display to show END PGM momentarily, and
then move on to show the first track in the play list.
Deleting a Track from a You may delete any selection from a play list.
Play List
To delete a selection:
1. Load a CD for which you’ve already saved a program (the letter
P will appear preceding the track number on the display).
2. Make sure that the Nº390S is in the programming mode by
clicking the mode button until you see PROGRAM in the
display.
3. Press next/f.fwd. The display will show the first selection in
your program.
4. Press next/f.fwd until the selection you want to delete appears
on the display.
5. Press mode – ; the display will remove the P from the displayed
track to indicate that it has been removed from the play list.
6. Repeat steps 4 and 5 for each selection you want to erase from
your program.
7. If you would like to make this change permanent, press and
hold mode + when you finish erasing selections from your
program; the display will show REVISED.
Adding a Track to a You also may add a selection to a previously saved play list.
Play List
To do so:
1. Load a CD for which you’ve already saved a play list (the letter
P will appear preceding the track number on the display); or
load an unprogrammed CD, then assemble and save a play
list.
2. Make sure that the Nº390S is in the programming mode by
clicking the mode button until you see PROGRAM in the
display.
3. Using the next and previous (or the numbered buttons on the
Remote Control), select the track you want to add to your
play list.
4. Add the selection to your play list by pressing mode +. Your
new selection will be added to the end of your existing play
list.