McIntosh C41 - Manual (Page 13)

13
How to Operate the C41
How to use a Signal Processor
Access and operate a signal processor connected to the
LISTEN PROCESSOR jacks by pressing the front panel
LIS (Listen) PROCESSOR push-button. This processor
will affect only the
LISTEN signals.
Refer to figure 4.
Access and operate
a signal processor
connected to the
RECORD PRO-
CESSOR jacks by
pressing the front panel REC (Record) processor push-but-
ton. This processor will affect only the RECORD signals
sent to tape recorders.
Reset of Microprocessors
In the event that the controls of the C41 stop functioning,
there is a built-in user reset function. Press the POWER
switch to the OFF position, wait for two minutes. Then
press the POWER switch to ON, the Red LED above the
STANDBY/ON Pushbutton, lights to indicate the C41 is in
Standby Mode. To turn on the C41 press the STANDBY/
ON push-button.
Note: The above condition is usually caused by either
interruptions in AC power and/or major changes in
voltage.
Figure 4