McIntosh C41 - Manual (Page 7)

7
C41 Rear Panel Connections and Switch
Connect the C41
power cord to a live
AC outlet. Refer to
information on the
back panel of the
C41 to determine
the correct voltage
The EXT (exter-
nal) SENSOR jack
allows the connec-
tion of a McIntosh
IR sensor for re-
mote operation
DATA PORTs send
signals to compatible
source components to
allow control with the
remote control
POWER CONTROL
MAIN Output sends a
turn-on signal to a
McIntosh Power Am-
plifier when the C41
is turned on
POWER CONTROL
1 and 2 Outputs
send a turn-on signal
to a McIntosh Power
Amplifier when the
C41 Front Panel
Output 1 and/or 2 is
on
MAIN Balanced
OUTPUTS contain
Listen program
signals at all times
LISTEN MAIN
OUTPUTS con-
tain Listen pro-
gram signals at
all times
LISTEN OUTPUTS
1 and 2 contain Lis-
ten signals and turn
on/off with the front
panel OUTPUTS
push-buttons
LISTEN PROCESSOR
FROM and TO allows
an external signal pro-
cessor to be connected
for use in the Listen
mode
RECORD PROCESSOR
FROM and TO allows an
external signal processor
to be connected for use in
the Record mode
CD1 balanced INPUTS
accept high level program
source signals
TAPE 1, TAPE 2,
T3/DVD, TUNER,
CD2, VIDEO IN-
PUTS accept high
level program source
signals
TAPE 1, TAPE 2
and T3/DVD
OUTPUTS con-
tain record out
signals
AUX accepts high level
program source signals,
PH accepts signals from a
Moving Magnet phono
cartridge, and the small
slide switch selects which
one of these two inputs is
active when either front
panel LISTEN or
RECORD switch is set to
PH/AUX
POWER CONTROL
ACC Output sends a
turn-on signal to a
McIntosh Power
Control unit when the
C41 is turned on
GND terminal
accepts a
ground wire
from a turn-
table