Minolta CD-10 - Manual (Page 24)

22
The PCMCIA Card Drive CD-10 connects to Adaptec’s
SCSI board. It also uses Adaptec’s software driver EZ-SCSI.
This section assumes that Adaptec’s SCSI board and EZ-
SCSI software are installed. For installation of the SCSI
board and EZ-SCSI, consult the manuals for those items.
When connecting the CD-10 drive to the computer with
EZ-SCSI installed, the EZ-SCSI software should be rein-
stalled after connection.
Applicable environment
The CD-10 drive can be used in the following environment:
- SCSI board :
AHA-1542CF
- Software driver: EZ-SCSI V.3.04
- Operating system: MS-DOS 6.20
- Windows: Ver. 3.1
Checking the EZ-SCSI driver
(1) Check the directory in which the EZ-SCSI software is
installed. In general, EZ-SCSI is installed in the “SCSI”
directory. In this directory, the following two files must
be stored: ASPIxDOS.SYS and ASPIDISK.SYS
CAUTION: EZ-SCSI may be installed in directories with names
other than “SCSI”. In the directory where EZ-SCSI is installed,
there are usually various utility files as well as ASPIxDOS.SYS and
ASPIDISK.SYS.
(2) When EZ-SCSI is properly installed, the CONFIG.SYS
file must contain the following two lines:
DEVICE=C: SCSI ASPIxDOS.SYS /D
DEVICE=C: SCSI ASPIDISK.SYS /D
* ASPIxDOS.SYS, the ASPI DOS manager, depends
on the SCSI board. See following Note.
Windows 3.1 and DOS